To protect Missouri's cave wildlife and water quality, use best practices when building on karst topography.
Karst is sensitive wildlife habitat
Karst features range from sinkholes, vertical shafts, losing streams and springs, to complex underground drainage systems and caves. These features are the result of the dissolving action of water on carbonate bedrock. Underground drainage systems can be extensive; as a result, specific karst features can be impacted by disturbances occurring miles from the affected area.
Associated with karst features are unique plants and animals that have at least part, if not all, of their life cycle dependent upon the unique environment of these systems. Even slight alterations or disturbances can have significant impacts upon these plants and animals. It is of utmost importance that construction projects in known karst topography be extremely sensitive to the potential impacts that may occur and that all possible precautions be taken to prevent or reduce those impacts.
It is often difficult to delineate clearly the type and extent of karst features present due to the complex and varied processes involved in their formation. However, it is important to identify and delineate karst features correctly so that these areas are managed properly for the resident species (for example, a bat hibernaculum or a bat maternity cave).
- Initial investigation should include the use of state, federal and private geotechnical data. Observation by a geotechnical consultant should be considered if existing data indicate the presence of karst features in the vicinity. Initial geological investigation of the immediate and surrounding area of the proposed project site should be conducted to determine the presence and type of karst features.
- The identification and delineation of karst features should include the following: location, distribution and dimensions of rock cavities; location, distribution and dimensions of soil voids; depth and configuration of the rock surface; variation in the physical characteristics of the subsurface soils and rock; groundwater quality and flow patterns.
Access and staging-area management recommendations
Staging areas are those short- or long-term sites within a construction or development area where most equipment and materials are stored. These areas are often accessed frequently, and when fuel and oil are stored here, the potential for accidental spills to leak underground may be high.
- Erosion and sediment controls should be installed and maintained to prevent discharge from the site.
- Staging areas for crew, equipment and materials should be established well away from karst features such as caves, sinkholes and springs, and highly erodible soils when practical.
- Stationary fuel and oil storage containers should remain within a staging area or another confined area to avoid accidental introduction into the groundwater. The storage should include a liner to ensure that fuel does not leach into the groundwater.
- Excess concrete and wash water from trucks and other concrete mixing equipment should be disposed of in an area well away from karst features, streams and wetlands.
- If temporary roadways must be built, ensure that roadways are of low gradient with sufficient roadbed and storm water runoff drains and outlets. Appropriate containment basins, filter strips, etc. should be included for retention of stormwater runoff as a means for reducing sedimentation introduction into karst features and groundwater.
Buffer-zone management recommendations
The buffer zone is the vegetated area immediately surrounding the karst feature, which helps slow runoff and filter out pollutants that might enter karst systems. A buffer zone of at least a 100-foot radius should be maintained on all sides around caves, sinkholes and springs.
- Buffer zones located down slope of construction areas should be physically screened with sediment controls, such as or filter strips. Sediment controls should be monitored after rain and maintained for the duration of the project, and removed at the end of the active construction period.
- General application of pesticides, herbicides or fertilizers within the buffer zone should be prohibited to avoid contamination due to over-spray or runoff. Fertilizer use or spot application of pesticides and herbicides is acceptable if appropriate non-restricted chemicals are used.
- All buffer zones disturbed by the project should be revegetated immediately following or concurrent with project implementation. Native trees, shrubs and grasses should be planted to ensure long-term stability in areas where the soil erosion threat is not critical. Annual non-native cover crops (e.g., grasses such as rye or wheat) may be planted in conjunction with native species to provide short-term erosion control. Areas judged to be subject to immediate soil loss due to steep slopes or other factors causing critical erosion conditions may be planted with non-native mixtures or covered with erosion control materials such as fabric, tubes, scour boards, or adhesive that is mixed with seed and sprayed onto the area.
- Post-construction evaluation of vegetation establishment should be conducted at one-month intervals for at least three months after completion of the project. Any recommended sediment controls should be inspected at these times. Proper clean-up of the temporary erosion controls will be necessary.
Karst-area management recommendations
Karst areas provide habitat for a diversity of highly specialized and sensitive vertebrate and invertebrate animals. These areas also provide an important filtration system for the underground water humans use and drink. For this reason, it is important to avoid rerouting waterways and drainage patterns in karst areas.
- All construction debris, refuse, discarded containers and any other waste materials should be stored away from karst areas. It is imperative to contain this material to prevent its accidental introduction into caves, sinkholes or springs as a result of cleanup activities, runoff, flooding, wind or other natural forces.
- Sediment erosion controls appropriate to soil type, water flows, exposure and other site-specific factors should be implemented during all phases of construction.
- Sediment erosion controls should be monitored periodically. Clean, repair and replace controls as necessary.
- Final revegetation of disturbed areas should use native plant species. Cover crops, such as rye or wheat, may be used with non-native mixtures initially to maintain soil stability until establishment of native vegetation can be completed. A monitoring program should be included in the project proposal to ensure successful revegetation efforts.
- All temporary sediment erosion controls should be removed (unless removal would cause further disturbance) and disposed of within 30 days after final site stabilization is achieved or after temporary practices are no longer needed.
- All debris and excess materials should be removed and properly disposed of upon completion of project.
For further information regarding regulations for development in karst areas, contact:
U.S. Fish and Wildlife Service
Ecological Services Field Office
101 Park DeVille Dr., Suite A
Columbia, MO 65203
U.S. Environmental Protection Agency
Water, Wetlands, and Pesticides Division
901 North 5th Street
Kansas City, KS 66101
U.S. Army Corps of Engineers
700 Federal Building
Kansas City, MO 64106-2896
Missouri Department of Natural Resources
Division of Environmental Quality
P.O. Box 176
Jefferson City, MO 65102-0176
Missouri Department of Conservation
Policy Coordination Section
P.O. Box 180
2901 W. Truman Blvd
Jefferson City, MO 65102-0180
These best management practices were prepared by the Missouri Department of Conservation with assistance from other state agencies, contractors and others to provide guidance to those people who wish to voluntarily act to protect wildlife and habitat. Compliance with best management practices is not required by the Missouri Wildlife and Forestry Law nor by any regulation of the Missouri Conservation Commission. Other federal, state or local laws may affect construction practices.